(352) 631-6521 Serving all of Hernando County Licensed & Insured · FL CCC1333347

Guide

What an Asphalt Shingle Roof Replacement Company Should Check, Slope by Slope

A shingle roof does not wear evenly, so it should not be judged as one thing. Here is the list an inspector works through on each slope, what each sign means, and which ones point to a repair rather than a new roof.

Shingle roofsInspection checklistRepair or replace

Why each slope gets its own line in the report

A shingle roof is several roofs sharing a ridge. Each slope faces a different direction, takes a different amount of sun, and catches wind from a different side. The slope that faces the afternoon sun usually wears first. The slope that faces the open lot usually takes the wind.

So the inspection goes one slope at a time, and every finding is tied to a slope. A report that says the shingles show wear does not tell you much. A report that says the rear slope has granule loss and the front slope is sound tells you where the work would go and where it would not.

It also matters for the decision at the end. One worn slope on an otherwise sound roof is a different conversation from the same wear on every slope. The checklist below is run on each one.

A shingle roof is several roofs sharing a ridge, and they do not wear at the same rate.

Granule loss and blistering

The granules on a shingle are not decoration. They shield the asphalt underneath from the sun. When they wash off, the asphalt is exposed, and it dries out and gets brittle from there.

Granule loss shows up as dark patches or smooth, shiny areas where the surface used to be rough. On the ground it shows up as grit in the gutters and at the downspout outlets. Some loose granules on a new roof is normal and settles down. A steady supply on an older roof means the surface is wearing through.

Blisters are small raised bubbles in the shingle surface, usually from moisture or heat trapped in the shingle. When a blister pops it leaves a pit with no granules in it. A few scattered blisters are a watch item. Blistering across a whole slope often points back to the attic, because a roof that cannot vent heat cooks its shingles from underneath.

Neither of these is a leak on the day it is found. Both are a measure of how much surface the shingle has left, which is why they get photographed slope by slope.

Cracked, creased or lifted tabs, and nail pops

A tab that has lifted in wind and come back down often leaves a crease across it. From the driveway it looks flat. Up close the crease is a line where the mat has bent, and the seal strip underneath has usually let go. That tab will lift again in the next blow, and sooner or later it tears off.

Cracks run through the tab and let water reach the layer below. Curling is when the edges or corners turn up as the shingle dries and shrinks. Each of these is checked by hand, by lifting a tab gently and seeing whether it is still sealed down.

Nail pops are fasteners that have backed out and pushed up the shingle above them. They come from heat cycling, from nails driven at an angle, and from decking that has gone soft and stopped gripping. A popped nail leaves a hole where it used to be, and it can wear through the shingle that sits over it.

A handful of lifted tabs or nail pops is a repair. The same thing scattered across every slope says something about how the roof was nailed or what the deck is doing, and that goes in the report as its own finding.

Ridge cap and hips

The ridge cap is the row of folded shingles along the peak, and on a hip roof it runs down each hip as well. It sits highest, takes the most sun and the most wind, and it is bent over a ridge, which puts the shingle under strain from the day it goes on.

So it is often the first part to crack. The inspector looks for splits along the fold, missing pieces, caps that have lifted at the exposed end, and nails showing where they should be covered by the next cap.

If there is a ridge vent under the cap, that gets checked too. A cap that has lifted over a vent is an open slot at the top of the roof. Rain that would run off a sound ridge gets blown straight into it.

Ridge cap can be replaced on its own. Worn ridge on a sound roof is a repair, and it should be written up as one.

Flashing seals, and what the list adds up to

Last on each slope is everything that interrupts it: vent boots, step flashing at walls, valley metal, chimney or skylight flashing, and the drip edge. The inspector looks at the rubber collars on the boots for splits, at the sealant along the top of any flashing for cracks or gaps, and at whether the metal is still tucked under the shingle above it rather than sitting on top of it.

Most leaks on shingle roofs start here, not in the shingles. A split boot or a dried-out bead of sealant is a small, specific fix, and a sound roof with one failed boot does not need replacing.

Put together, the checklist answers one question. Is the wear isolated, or is it everywhere? Isolated damage on a roof with surface left is a repair. Granule loss, brittle tabs and cracked caps across most of the slopes is a roof near the end of its surface, and patching it means paying to fix the same thing again. The report should say which, with photographs, and if both options are real it should show both.

It should not put a number of years on what is left, because nobody can say that honestly for a specific roof. And we will not name a price until we have been up and looked. Work is performed by GenX Roofing LLC, Florida Certified Roofing Contractor, license CCC1333347.

Straight answers

Common questions

Do some loose granules in the gutter mean I need a new roof?

Not on their own. A new roof sheds some loose granules for a while and then settles down. What matters is how much, how long it has been going on, and whether the shingles have bare or shiny patches to match. That is something to look at slope by slope, not judge from the gutter.

Can a few lifted or creased tabs be repaired?

Usually, yes. Individual tabs can be resealed or replaced. The question is whether it is a few tabs on one slope or a pattern across the whole roof. A pattern says something about the nailing, the seal strips or the age of the shingle, and a repair will not fix that.

How many years does my shingle roof have left?

We do not know, and nobody can tell you honestly. Ventilation, installation, sun exposure and storms pull in different directions, and two roofs put on the same week can end up in different condition. What an inspection can tell you is what condition each slope is in now, with photographs to show it.

Will this inspection help with my insurance?

It gives you a dated record of the roof's condition with photographs, and you can send that to anyone. What your carrier does with it is between you and your carrier, and we will not predict it. We also do not complete or sign wind mitigation or four-point inspections. A roofing license does not qualify under Florida Statute 627.711(2).

Where to go next

What we actually do

01

Roof Inspection

Roof condition reports for insurance renewals and four-point requests, pre-purchase checks, and honest remaining-life assessments.

View
02

Roof Repair

Cracked and lifted shingles, failed pipe boots and flashing, ridge cap damage, nail pops and exposed fasteners.

View
03

Roof Replacement

Architectural shingle, standing-seam metal and tile. Full tear-off, deck inspection, code-compliant rebuild.

View